Logo

C1250 Engine Trouble Code

Meaning of C1250 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C1250 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for C1250 code is occuring now you should check C1250 repair processes.
Now don't ask yourself; What should you do with C1250 code ?
The solution is here :

C1250 Possible Solution:

C1250 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

C1250 Code Meaning :

C 1 2 5 0
OBD-II Diagnostic Chassis (C) Trouble Code For Engine Fuel And Air Metering Manifold Absolute Pressure/Barometric Pressure Circuit High Input Cylinder 1 Injector Circuit Low Shift Solenoid E Performance or Stuck Off

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C1250 OBD-II Diagnostic Chassis (C) Trouble Code Description

C1250 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For C1250 Code

The reason of C1250 OBD-II Engine Trouble Code is Manifold Absolute Pressure/Barometric Pressure Circuit High Input.

C1250 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.